Alaska - Indonesia - Central America - Australia - and across the USA
Spread: portland, quicklime, fly ash, bentonite, hydrated lime, kiln dusts and blends.
Over 100 in service worldwide.
|
|
|
||
| Rebuilding runway. Watch the video.Saint Paul Island, Alaska May-June 2005 |
Apply 1.9 lb/sq.ft. (+/- 0.1 lb) in 30-40 mph winds with zero dust. Followed by foamed asphalt and mixed 15" deep. |
||
|
|
25 ton Site Spreader in Jakarta, Indonesia preparing for an extended highway project. | ||
|
|
Transfer 27 tons of Portland in less than 30 minutes with no dust from the spreader. | ||
|
|
Preparing soil for the new 380 Airbus at Chicago OHare airport. | ||
|
|
Pull-type spreader stabilizing a base for a future mall. | ||
|
|
Highway reconstruction. PA Rt 283 East. | ||
| DUST CONTROL | |||
|
|
FILLING:
Air from the tanker is filtered before venting. |
||
|
|
Inside the filter can hang 300 filter tubes. Each tube is 1" x 36" for a total surface area of 235 sq.ft. of filter. Maximum air flow of 1,100 cfm. |
||
|
|
SPREADING:
NESCO "Micro-mist" dust control uses only 1.5 gpm of water. |
||
| While spreading 1% portland in Alaska with 35 mph winds, the "Micro-mist" not only captured the dust, but put a very thin damp cap on the cement to prevent being blown away. | |||
|
|
The pneumatic fill pipe (behind cab) allows for filling directly from the tanker truck. While spreading, dust is contained by "dust curtains" hanging below the folding booms (shown) or the auger. | ||
| SPREADER MODELS | |||
|
|
|||
|
|
Pull-type spreaders are also available, up to 25 ton capacity. PTO unloads the hopper. The auger, auger sections and rear gate are hydraulic. Auxiliary engines available. | ||
|
|
Open top spreader for granular materials and small jobs. 5, 8 and 15 ton models. PTO body chain and hydraulic spreading auger. | ||
|
|
Trailer units to 25 tons. Engine packages and radar / GPS computer control optional. |
||
|
|
Truck mounted units can be large enough to hold a full tanker, i.e., 27 tons. | ||
|
|
The spreader auger (8, 10 or 12 ft wide) with tapered openings delivers a level pattern, up to 100 lb / sq.yd. |
||
|
|
Preparing a county road for reclamation. Target rate: 25 lb / sq.yd. | ||
|
|
25 ton hopper with
lots of flotation.
|
||
|
|
THE BASIC SPREADER The Stoltz Site Spreader uses a 30" wide drag chain to unload into the spreading auger. The gate opening over the chain determines the rate per sq.ft. The level pattern is obtained by adjusting slots under the auger trough. |
||
|
PRESSURE RELIEF
9" Silo Vent relief valve set at 2 psi.
|
FILL CONTROL Digital Scales Bin Indicators |
||
| The Floating Spreader... | |||
|
|
UNDER CONSTRUCTION As of: October 20 Barge-mounted bentonite spreader for sealing leaking ponds without draining them. Powered by 58 HP Deutz, GPS guided and supplying application maps. |
||
|
|
IN OPERATION October 31, 2003 Applying 3 lb/sq.ft. at 2 mph.
|
||
![]()
Stoltz Mfg., LLC: 121 Morgan Way, P.O. Box 527,
Morgantown, PA 19543
Tel: 610.286.5146 | Toll Free: 800.843.8731 |
Fax: 610.286.6600
© 2003-9 Stoltz Mfg., LLC. All rights reserved.